AudioB I2S Bluetooth Digital Audio Receiver Module - I2S master
20 or more $10.45
If you want to build a digital Bluetooth amplifier board, AudioB I2S Bluetooth audio receiver module is a good choice for your project. This is a Bluetooth 5.0 stereo recevier module, I2S digital output and music resampling frequency is 48KHz. This module supports Apt-X, and is based on QCC3008. We breakout pins to 2x10 2mm space male pins. You can integrate it to your project easily. If you want a demo board. Please buy our TSA7010 Digital Bluetooth Audio Receiver. It's a AudioB I2S module + DAC board.
The module PIN7,8,9,10 are I2S output pins, I2S voltage 1.8V.
- 7 - GND
- 8 - BCK I2S synchronous data clock, It's a 2.304MHz square wave signal.
- 9 - SD I2S synchronous data output.
- 10 - LRCK I2S word select, 48KHz. 1 - Left channel data, 0 - Right channel data.
- Setting switch: We set to I2S in normal state. Set to SPI when you need to program the module.
Note1: You need to set the on board switch to SPI when you program the module
Note2: You need to change this module from I2S master to I2S slave. if you want to use it on our digital audio amplifier boards.
Note:
- Quick press S2 to switch to the previous song, long press to reduce the volume
- Quick press S3 to switch to the next song, long press to increase the volume
- Press S1 to play or pause
- if there is an audio output, MUTE pin will be high level, otherwise, it will be low level.
Features:
- Bluetooth 5.0
- I2S digital output
- Sampling Rate: 48KHz
- Bit per Sample: 16 bit
- Left Justified
- Justified Data 1 bit delay
- Apt-X supported
- Low power consumption: 5mA@5V
- HFP V1.6
- HSP V1.2
- A2DP V1.2
- AVRCP v1.4
- Support for smartphone application(APPs)
Documents:
- How to change the BT name
- Bluesuite2.5.0
- Dimensions
- Firmware(I2S)
- How to change this module from I2S master to I2S slave
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
